LIS3DH BREAKOUT BOARD

Available Package Options

• Bare LIS3DH Breakout board without parts
• Kit with all parts. Not assembled
• All parts assembled and ready to hack!

Kit and assembled options contains

• LIS3DH sensor
• 8 way MOLEX pig-tail wire (additonal can be bought here)
• parts.

Related products

• RT-NVT2008 Bidirectional SPI/i2C Voltage Level Translator
• How you can easily fasten the sensor? Try the Hook and loop tapes.

What is it?

The LIS3DH has user-selectable full scales of ±2g/±4g/±8g/±16g and is capable of measuring accelerations with output data rates from 1 Hz to 5.3 kHz. The device may be configured to generate interrupt signals using two independent inertial wake-up/free-fall events as well as by the position of the device itself. Thresholds and timing of interrupt generators are programmable by the end user on the fly. The interrupt signals can be connected to the transistor driving LED. The interrupt signal INT1 is default connected to the on-board LED. Both INT1 and INT2 are connected to the MOLEX connector.

The LIS3DH has an integrated 32-level first-in, first-out (FIFO) buffer allowing the user to store data in order to limit intervention by the host processor.

LIS3DH Evaluation Module Features

• User selectable ±2g/±4g/±8g/±16g measurement range
• Up to 1mg resolution
• 12bit ADC built-in
• Built-in digital High-Pass filter
• Acceleration measurement bandwidth from 0Hz, up to 2688 Hz
• Output data rate up to 5376 Hz
• Operating voltage 1.71-3.6V
• Supply current less than 0.2mA
• Operating temperature range -40 – 85 degC
• Interfaces: SPI (=<10MHz), I2C(=<400kHz)

Maximum non-destructive acceleration 3000g for 0.5 ms, 10000g for 0.2ms

Sensor is suitable for

• Motion and free-fall detection
• Inclinometer applications
• Digital spirit level
• Vibration measurement
• Platform stabilization
• Speed measurement

Code

Standard C platform-independent drivers for MEMS motion and environmental sensors : st.com

Android sensor HAL for MEMS motion and environmental sensors: st.com

PRODUCT DESCRIPTION

• Two layer PCB breakout board for LGA-16 (3x3x1mm) - Hand solder capable.
• SMD Molex socket type: 53261-08
• PCB dimensions: 22x26x1mm

FEATURES

• Small dimensions
• PCB can be screwed or glued to the object surface
• Additional transistor and LED connected to the interrupt pins
• All LIS3DH signals connected to the Molex socket
• Gerber file for the SMT stencil to download
• Sensor footprint designed for hand soldering

PINOUT

• 1 SDO – Slave Data Output
• 2 SDI – Slave Data Input
• 3 SCL – Slave Clock Input
• 4 CS – Chip Select
• 5 INT2 – Programmable Ready/Interrupt pin
• 6 INT1 – Programmable Ready/Interrupt pin
• 7 GND - Ground
• 8 3.3V – Supply Voltage

DATASHEET

ST LIS3DH product page

LIS3DH Datasheet

MECHANICAL DRAWING

ASSEMBLY DRAWING