Kits now ship with the new AATINY84A-PU Micro

Designed as a fun side project, this platform uses an ATtiny84 Micro with more IO's than its brother the 85. V0.1C is the current version, Its exactly the same as in the product photo but instead of a 10(ten) pin header there is a standard 6 pin ICSP header on board. V0.1C is a bit smaller to maximize the use of a pcb panel.

Features

• low voltage 6.1V max on main power input, 5.5V max on VCC pin input.
• Reverse polarity protection, great for beginners (you wont blow up your micro).
• Compatible with Arduino 1.0+ IDE, and Atmel Studio.
• Low power RISC based mirco.
• 8KB ISP flash memory.
• 512Byte's of EEPROM storage.
• 512Bytes SRAM.
• 6 GPIO's (General Purpose IO).
• 1 x 8bit Timer with compare modes, 1 x 16-bit high speed timer/counter, USI, internal/external interrupts, 4-channel 10-bit A/d(analog to digital) converter.
• running on internal 8Mhz clock (1Mhz factory configured), can run at max 20MHz with external crystal and fuse programming.
• programming is done via ICSP (USBisp's can be bought in my store).
• ATtiny is hot-socketed, you can replace the micro anytime (or use the platform as a programmer extension).
• All IO pins are brought out to the sides of the board, Perfect for bread boarding.

What you will get

This is a kit with few easy to solder parts. The total parts count 13 hand solder-able through hole components. The ATtiny85 micro's do not come with a bootloader and therefore will need to be programmed via ICSP in some fashion.

Disclaimer

Board color and finish may vary, I like oshpark but when it comes to mass quantities they are not really the best option. However for ENIG gold finish they are current in my opinion the best option as a US based fab, most boards will be manufactured with fusion PCB with HASL finish, these are not PB free boards!. This allows me to do smaller quantities and still be able to sell these products at a lower price then I would normally have to sell them at.