What is it?

This E-ink display module is special made for E-ink display development, no need to build any additional circuit and component, you can run this E-ink display module directly with your project.

Why did you make it?

One years ago we made the first e ink module for the makers and developers, this time we made some changes on the pins, becuase the pin headers of the first module is a little urgly and hard to dissemble. So we change the pin header to SMD 180 degree female header, users can freely assemble this module to your project, and looks better.

What makes it special?

Features:

• Ultra low power consumption
• Super wide viewing angle - near 180°
• Extra thin & light
• High Resolution
• SPI and I2C interface
• Four gray shade colors
• All necessary component included
• Integrating boosted circuit
• Maintains a clear display in the power-off state

Specifications:

• Resolution: 172x72
• Display thickness: 1.18mm
• Display Dimension: 2.04inch,
• Module dimension: 30.13x60.26mm
• Pixel Pitch (mm): 0.28(H) X 0.28(V) / 95dpi
• Contrast Ratio: 10:1
• Display Color: 4 gray shade colors, White, Gray, Deep gray, Black
• Refresh Time (room temp.): 1 sec
• Interface: SPI
• Operation Temperature: 0~50°C
• Storage Temperature: -20~60°C
• Module Weight: 15g

Interface:

• 3.3V: 3.3V
• BS1: Bus interface selection pin, low is 4-line SPI interface, high is I2C interface.
• BUSY: E-ink Device Busy Signal, When Busy is High, the operation of the chip should not be interrupted, command should not be sent.
• RES: E-ink reset pin.
• D/C: E-ink Data or Command control pin.
• CS1: E-ink select input pin
• SCL: I2C clock pin/ SPI serial clock pin.
• SDA: I2C data pin/ SPI MOSI pin.
• GND: Ground