Known Restrictions, First Thing First

• CH32V003 instruction set is optimized for control applications, instead of computation tasks.
• CH32V003 blank chips are shipped without bootloader, use WCH serial debug interface (SDI) debugger to download.
• CH32V003 blank chips can only be programmed by WCH-LINK-E with SDI.
• All documents in English are proofread for global developers.
• More restrictions will be collected and appended here.

A Low Cost RISC-V MCU

WCH is well-known for its USB interface IC family. Its RISC-V MCU family also expands quickly. CH32V003 is an ultra low cost entry level RISC-V MCU suitable for small products or projects. It features:

• 32bit RISC-V 2A Core
• Up to 48MHz system clock
• 2KB SRAM and 16KB user flash
• 1x DMA controller
• 1x OpAmp comparator
• 10-bit ADC
• 1x 16-bit advanced timer and 1x 16-bit general purpose timer
• 2x watchdog timers and 1x 32-bit system-tick timer
• 1x USART
• 1x I2C
• 1x SPI interface
• Up to 18 I/O ports, interrupt is available on all pins
• 64-bit chip unique ID
• Serial 1-Wire Debug Interface
• Multiple low power modes: sleep, standby
• Supply voltage: 3.3/5V
• Power-on/power-off reset, programmable voltage detector

An Awesome Low Pin Count MCU for DIYer

Why TSSOP20 is perfect for DIYer? Because it is the most user-friendly package for DIYer. NXP used to offer DIP20 of LPC MCU for the DIYer. But DIP was too expensive. That is the reason why new boards including Arduino Nano/Raspberry Pi Zero leverage 100mil DIP pinout, with QFP/QFN package on board.

Compare to QFN, TSSOP20 is easier to handle.

Revised User Friendly EVB

WCH has it own EVT (Evaluation Tool), which has simpler design and low cost. The Revised EVB features:

• One through-hole external crystal soldering pad to use low cost 8MHz crystal.
• USB Type-C connector offers 5V power supply
• On board USB/UART bridge IC to print out the debug information via serial port.
• One power switch
• One PWR LED
• Two user LEDs
• Two user buttons
• One reset button
• WCH SDI debug interface

The design adds USB/UART and user buttons/LEDs for user interactions. So only two USB ports are used during development: PWR+DBG. Or you can use WCH-LINK-E to support power, UART and DBG.

For people who still wants the official EVT from WCH, please visit our store for detail.

Revised WCH-LINK-E

WCH offers various WCH-LINK debuggers, since the company offers ARM and RISC-V MCUs. Only WCH-LINK-E is suitable for CH32V003 and newer RISC-V microcontrollers. The interface also supports Keil and ARM Cortex-M microcontrollers from WCH.

This version of WCH-LINK-E is a clone and has been verified for compatibility.

We also offer the official version, please visit our store for detail.

Samples

The blank samples are suitable for the developers who wants to design their own boards. CH32V003 makes its bootloader area available for developers who want a custom bootloader or use all the memory completely.

The developer has to program the chip with WCH-LINK-E at first time. An open source bootloader is also available in the software library.

The samples have to be ordered separately. The packages/quantities can be arranged on request.

Support

• Get Started manual is hosted on a Gitlab repo.
• More restrictions will be collected and updated to the same repo as well.