PandwaRF Bare is the developer version of PandwaRF. It is a bare PandwaRF development board, with debug pins, GPIOs and an SMA connector for external antenna, ready to receive your own FW. No FW included.

Technical Specs

• Bluetooth Smart Module ISP130301, based on nRF51
• CC1111 Low-Power SoC with Sub-1 GHz RF Transceiver
• Multi frequencies (from 300 MHz to 928 MHz)
• Multi modulation (ASK/OOK/MSK/2-FSK/GFSK)
• Transmit and receive in half duplex mode
• Support data rates up to 500 kBaud
• Open hardware
• Full speed USB: 12 Mbps (Linux or Android)
• USB charging
• 4 buttons to assign codes
• 4 Status LEDs
• 16 Mbit Flash Memory to save custom RF protocols
• RX amplifier for improved sensitivity: +13dB from 300MHz-1GHz
• TX amplifier for higher output power: +20dB @ 433MHz & +17dB @ 900MHz
• SMA connector for external antenna
• Antenna port power control for external LNA
• 22-pin expansion and programming header
• Battery, case & antenna not included

Warning: there is no FW flashed on this version.

For guidelines on using PandwaRF Bare, make sure to check the Hardware Programming section of our wiki.