Buy with confidence.
Our Tindie Guarantee protects your purchase from fraud. Learn More
Visit the official website for the user guide and more info: edispenser.pira.mx Key features: Easy to use, fill and swap syringes in a few seconds. 3 Dispensing modes: Manual, Timer and Dot mode.…
Read More…Visit the official website for the user guide and more info: edispenser.pira.mx
Key features:
Easy to use, fill and swap syringes in a few seconds.
3 Dispensing modes: Manual, Timer and Dot mode.
Small footprint (9x7cm) no compressor needed, use any USB-type charger.
Pick up mode: using a second empty syringe (included) you can pick up SMD components straight from the tape for faster and easier board assembly.
Compatible with simple external switches and other programmable devices like 3D printers and CNCs, making automated dispensing possible*
Rubber caps for dispensing tips. You can store left over material for later use by removing the motor and sealing the tip with a rubber plug (two sizes included)
USB type-C input for power.
Compatible with all phone or tablet chargers.
Precision pistons manufactured in-house:
CNC-Machined from solid brass and nylon for added strength, better concentricity, less friction and backlash.
Custom design allows the user to replace the piston itself (the part that comes in contact with the material) with a simple screwdriver reducing the cost of spare syringes/pistons.
Full array of accessories available:
Foot switch.
Finger switch.
50cm (20in) extension cable for motor.
Extra syringes.
Extra tips, rubber caps and syringe couplers.
Extra piston holders.
Control unit.
Motor assembly.
2x empty syringes with caps and 2x piston holders, around 15cc effective volume each.
2x White pistons. For general purpose use: pastes, adhesives and medium to high viscosity materials.
2x Red pistons. Improve pick and place performance and helps to dispense low viscosity fluids and lubricants.
1x Coupler for easy fluid transfer between syringes.
1x Suction cup tip attachment for picking up large ICs.
2x Needle caps, small and large.
12 dispensing tips in the following sizes:
2x Conical size 18ga, 20ga and 22ga
1x Straight stainless steel, size 14ga, 20ga and 22ga
1x Stainless steel 45deg bent, size 14ga, 20ga and 22ga
For more information visit the online user guide.
For questions click on the "Contact seller" link on this page or in our site.
Note: For best results use the lowest viscosity paste you can get, solder pastes that come in pre-filled syringes are more likely to work right away than the ones sold in jars, for those you can add liquid flux and it will reduce the viscosity.
*Automated dispensing is for advanced users only: To integrate with a 3D printer or any other CNC head, you'll need to be familiar with writing g-code and have some basic electronics knowledge to interface with the external trigger port. Read the online user manual for more info.
Buy with confidence.
Our Tindie Guarantee protects your purchase from fraud. Learn More
/i/94235/products/2020-10-26T15%3A30%3A22.817Z-DM_main.jpg?1606306133)
