Doepfer style ribbon cables for Eurorack Modular Synths
Designed by Electronic things... and stuff in France
Buy with confidence.
Our Tindie Guarantee protects your purchase from fraud. Learn More
Eurorack modules require a special ribbon cable for their connection to the power supply bus. They are made with flat ribbon cable, and 2 IDC connectors. There are several variations of these cables,…
Read More…Eurorack modules require a special ribbon cable for their connection to the power supply bus.
They are made with flat ribbon cable, and 2 IDC connectors.
There are several variations of these cables, depending on your module requirements. Some modules only require the positive and negative rails (+12V / -12V) while some others require the additional +5V rail and even sometime use the CV and/or Gate signals present on the Power Bus.
Flat cable step: 1.27mm. Red or blue stripe shows pin #1. Pin #1 is usually connected to -12V rail.
However, you must never trust the red stripe!
Standard HE10 style ("IDC Sockets") female connectors. Height: 157.5mm, Width: 6.02mm. Length: 17.35mm (10-pin) or 24.97mm (16-pin). Datasheet
Eurorack 16-pin Full connection -12V / GND / +12V / +5V / CV / Gate power cables. 16 pin connector (2x8) on both sides. 25cm long. All the pins are connected (1 to 1).
Eurorack 10-pin -12V / GND / +12V power cables. 16 pin connector (2x8) on one side and 10 pin connector (2x5) on other side. 25cm long. On 16 pin connector, the connections start from pin 1 to pin 10. Pin 11 to 16 are not connected. On 10 pin connector, all the wires are connected (1 to 1).
Buy with confidence.
Our Tindie Guarantee protects your purchase from fraud. Learn More
$95.00
$46.00
$27.00
$25.00
$180.00
$19.00
$12.00
$25.00
/i/90072/products/2015-01-04T00%3A04%3A14.380Z-15816274558_e61c4587b5_c.jpg?1606306133)
