What is it?

• A very small (14 x 17 x 1.6 mm) breakout board to offer solid, clean and easy mounts and connections with passive through-hole (THT) components such as resistors, inductors, diodes and capacitors.

• Single layer PCB with lead-free HASL finish, 1 oz Copper, and FR-4 TG130 material

• A simple way to add external pull-up or pull-down resistors, voltage dividers, low pass filters, protection diodes and much more using only Dupont jumper wires, or to strengthen and neaten soldered solutions

• Avoid the need to solder loose components together, or to use a breadboard, strip board or custom PCB when only a few passive components need to be added to a circuit.

• Each board offers mounts for 4 passive components, to allow up to 4 pull resistors, 4 parallel resistors, one voltage divider of almost any ratio, or one single stage low or high pass RC or LC filter.

Why did we make it?

• Many occasions where we need to add only external pull-up resistors or other extremely simple passive circuits to an embedded system

What makes it special?

• Stronger and neater than directly soldering components

Options

(4x) PCB Only

• Four unsoldered boards for use with a wider variety of projects

(4x) PCB + Header

• Four unsoldered boards with four 2x5 pin headers for use with a wider variety of projects

(1x) 1K Soldered

• One board with 4x 1K ohm 5% 0.25W Resistors and a 2x5 pin header soldered on
• Useful for high speed data lines such as I2C at 400 kHz or 1MHz, used for Wii Ext (Mini NES/SNES Classic) BlueRetro systems

(1x) 3K6 Soldered

• One board with 4x 3.6K ohm 5% 0.25W Resistors and a 2x5 pin header soldered on
• Useful for low to medium speed data lines such as I2C at 100 kHz or slower, used for PAL NES and SNES BlueRetro systems