This is a bare board that is designed to be broken or cut to create two separate boards. This is a first version beta and is being made available on that basis.

When building or designing around the Intel 7110A magnetic bubble, it is convenient to have these two support boards. The top portion is a dummy module to simulate the resistance of the 7110 bubble module during board testing. Version Notes:

• To use with the leadless carrier 7110-1 version, the dummy load needs to be modified. The fingers for the leadless carrier are half a finger's width off in relation to the alignment key. I can do this for you before it ships if needed but it is a patch.
• The reseeding portion has not been tested as I still need to write the reseed software. So buy as-is.

The bottom portion of the board is a reseed module to recreate the seed bubble in case it has been destroyed. The reseed module is considered a prototype because I have not had the need for it or had the opportunity to write the required software. However, the design for both are in the SBC-85.COM bubble documentation and you can compare to the original intel design in the BPK72 user manual which is readily available online.

The design is as provided in the Intel bubble support documentation on the SBC-85.COM project site and all the components are readily available, information including BOM and instructions are the SBC-85 Bubble Memory Board documentation as well as the Intel BPK72 user's manual.