You are buying a kit to build a usb powered Christmas tree, it has 13 RGB led's and a pre programmed ATTiny85 micro controller.

The reason I built them is I decided that I would make a few pre Christmas gifts for a few of my fellow geeky friends at the Makerspace; I'm a member of fizzPOP. Rather than build them entirely myself I produced a kit so they could have some fun building them themselves.

You will notice that not all of the component positions are populated; this is intentional allowing opportunity for future hacking such as USB control.

The kit includes the following:-

• 1 x Upper Tree PCB
• 1 x Lower Tree PCB
• 13 x RGB Addressable 5mm LED's
• 13 x Kemet Multilayer Ceramic Capacitor, Gold Max, 0.1 µF
• 1 x Tactile Switch, Through Hole
• 1 x WURTH ELEKTRONIK Micro USB Connector, Type B, Through Hole
• 1 x 8 pin DIP Socket
• 1 x ATTINY 85 Micro Controller (Pre Programmed)
• 1 x Diode
• 1 x Resistor

You will also require, a Micro USB Cable and Power Supply (Not included). If you wish to change the program on the ATTINY 85 you will need a method of programming.