Description

The Smart Garden is an electronic board based on the ESP32 with the capability of controlling a combination of 4 irrigation valves and/or water pumps, supporting 24AC & 12DC voltages. It adds 8 auxiliary I/O (4 analog inputs) so you can also program the activation of each relay based on inputs.

Since it can be powered from 24VAC power supplies, you don't need to worry about extra powering for your solenoid valves.

For knowing more about its features, check out the online documentation.

Features

• ESP32-S2 module: since it is based on the extended ESP32 microcontroller you can upload the ESPHome firmware (Over the Air) and connect it with your Home Assistant setup or simply upload your own Arduino codes.

• Simplicity matters: No need to have any other cable than your standard USB-C, with its embedded port you can reprogram the Smart Garden in case you prefer not to do it wirelessly.

• Expandable: Want to read external sensors or control further boards? The Smart Garden integrates an I2C port as well as a serial port so you never run out of physical connections.

• Open-source: if you have any questions or suggestions about the design, just check out all the documentation and design files on my Github

What you buy

Select between the two assembly options the option that better fits you:

• Assembled: You will get a fully assembled Smart-Garden board, ready to power and configure.

• Kit: You will get a Smart-Garden board with all the SMD components already soldered and the THT (through hole) components to be soldered by you. You can check out what is placed where using the online BOM