What is it?

The BlueMacro840 is a nRF52840 controller inspired on the Adafruit nRF52840 feather but with the footprint of an Arduino Micro. It can be programmed using standard Arduino tooling and supports the Adafruit nRF52 libraries.

Why did you make it?

Many DIY keyboards use the Arduino Pro Micro or the Arduino Micro as their microcontroller. These don't support BLE communications natively. Because the nRF52 chips have a 32-bit ARM Cortex-M4F processor, they have plenty of processing power compared to the traditional AVR chips. The BlueMicro boards were inspired from the Adafruit nrf52 feathers but made to be used directly in DIY keyboards as a replacement for the atmega32u4 based controllers.

What makes it special?

The BlueMacro840 has the same footprint as the Arduino Micro. As such, it makes available 24 GPIOs for your own use. This board is great for upgrading pro micro based keyboards.

The BlueMacro840 has the following features:

• LiPo battery charger on board.
• USB-C Connector
• nRF52840 processor.
• Adafruit nRF52 Bootloader has been flashed.
• All 24 GPIOs were tested and a simple test firmware flashed.

Notes on 2021 Availability

Due to the ongoing chip shortage, the availability of E73-2G4M08S1C modules (with chip antennas) has been very difficult and their costs have increased significantly (if they can be found). E73-2G4M08S1CX modules are more readily available directly from the manufacturer but require an external antenna (included).