This is the PCB only version!

Currently I am out of stock from complete sets because of some EU/Austrian regulations!

What is it?

This is a LoRa Modem on an TTGO T-Internet-PoE ESP32 board. It is currently used for an APRS iGate for LoRa APRS.

Why did you make it?

Some time ago I had the issue that the current implementations for LoRa APRS are just running on Raspberry Pi. The Raspberry Pi is a good platform, but it is still too expensive in my eyes as an iGate can also run on one of the cheep ESP32 boards. So I started to develop a iGate Firmware for the ESP32 LoRa boards. After some time there was the need for an ethernet board.

What makes it special?

It is running more stable than the WiFi versions and is completely open source/hardware.

What will you get?

You will get the LoRa modem board only (PCB).

IMPORTANT: The TTGO T-Internet-PoE board and all parts for the modem board are NOT included! You have to order it by yourself via Aliexpress or Tindie from Lilygo.

What else do you need?

There are still parts which you have to order:

• LoRa Modem (Ra-02) (433MHz)
• OLED 0.96''
• 2 buttons
• 8x2 pinheader to connect to PoE board
• 6x1 pinheader to connect the programer board to the PoE board (this pinheader is not included in the PoE board)
• TTGO T-Internet-PoE board
• Pigtail from IPEX to SMA or 433MHz antenna
• 6x 3M spacer bolts
• 4x 3M 12mm screws
• 4x 3M nuts

This parts can be easily ordered on Aliexpress.