What is it?

Sometimes, electrical connections that you are convinced have been correctly made may not actually be properly connected.In other cases, you may be trying to figure out if a component has internally shorted or if there is a short between power rails. In these cases, the continuity probe is the tool for you! This kit allows you to create a continuity probe that sounds a beeper when two points are electrically connected.

However, this kit is better than just some simple buzzer circuit; this kit uses a special circuit that is designed to prevent damage to any circuit under test with the use of diodes and small comparison voltages.

Included in this kit

• 1 x 4093 IC
• 1 x LM358 IC
• 1 x 14 DIP Socket
• 1 x 8 DIP Socket
• 2 x 1K Resistor
• 2 x 5.6K Resistor
• 4 x 10K Resistor
• 3 x 100nF Capacitor
• 1 x 10uF Capacitor
• 2 x 1N4148 Diode
• 1 x Buzzer
• 1 x Switch
• 2 x Pogo Pin
• 1 x Wire
• 1 x PP3 Connector
• 1 x PCB

What makes it special?

MitchElectronics kits are designed with education in mind and as such use high quality double sided PCBs. The through-hole plating of each pad means that even the most novice of builders will not be able to tear traces or break pads (unlike many other professional kits which only use single sided boards to save costs). These kits are also RoHS compliant which make them safe to use and no kits use non-RoHS components such as LDRs (which contain Cadmium).