What is it?

A kit to make a Parallel Port Interface for the RC2014. It uses the 82C55 Programmable Peripheral Interface

Why did you make it?

Because I wanted to scratch the itch of whether I could get a parallel port printer working with RC2014.

This started off as an adaptor card for MG012, but I struggled to design one I was happy with. I decided that making a whole new card was better solution. I am offering this with an option to omit all ICs, so that MG012 owners can swap them across (and get a parallel port for not much more than the original adaptor card was looking like it would cost).

What makes it special?

The 82C55 is (was) fairly commonly used to implement parallel ports, MG014 wraps this up in a neat package.

What's included?

A PCB and all components required are included, including sockets for all ICs (there is an option to omit all ICs). A PDF with full instructions is available at the link below.

Please note I am now supplying new 82C55 I/Cs again for MG014, as they have now become available.

Please note that the peripheral (E.G. printer) and connecting cable are not included in this kit.

What else do I need to know?

I can't guarantee that MG014 will work with any and every parallel port printer (or for that matter, other parallel port peripherals). Please read the section "How can I tell if a printer will work?" in the instructions for guidance as to what is likely to play nicely.

MG014 has been designed for RC2014 with reference to the RC2014 Module Template. All pinouts used and the physical outline are in compliance with the RC2014 Module Template.

RC2014 is a trademark of RFC2795 Ltd.

MG014 has been designed for hobbyist use only and is not to be used for safety or business critical applications. The kit assumes basic through-hole soldering skills.

The payment of any import taxes and duties will be the responsibility of the Buyer.