Segmented Heat Bed for 3D printer,PandaBed

Name: Segmented Heat Bed for 3D printer,PandaBed
SKU: 26340
Price: 89.00 USD
Availability: InStock

This Heat Bed is Segmented heatbed with 9 individually controlled segments.

Designed by Mark in China

Segmented Heat Bed for 3D printer,PandaBed 1

Segmented Heat Bed for 3D printer,PandaBed 2

Segmented Heat Bed for 3D printer,PandaBed 3

Segmented Heat Bed for 3D printer,PandaBed 4

Segmented Heat Bed for 3D printer,PandaBed 5

Segmented Heat Bed for 3D printer,PandaBed 6

Segmented Heat Bed for 3D printer,PandaBed 7

Segmented Heat Bed for 3D printer,PandaBed 8

Segmented Heat Bed for 3D printer,PandaBed 9

2022-03-23T09:57:32.072Z-20310161018.jpg

Buy with confidence.

Our Tindie Guarantee protects your purchase from fraud. Learn More

This Heat Bed is Segmented heatbed with 9 individually controlled segments.

This Heat Bed is Segmented heatbed with 9 individually controlled segments. What makes it special? 1.Energy saving: Each bed segment can be discretely controlled with its own heater circuit, you no…

This Heat Bed is Segmented heatbed with 9 individually controlled segments.

What makes it special?

1.Energy saving:

Each bed segment can be discretely controlled with its own heater circuit, you no longer have to heat up the entire bed for smaller prints.

2.Heating evenly:

There are 3*3 separate zones each one have a thermistor that not only heating separately but also more even in heating than the normal print bed that have only one thermistor.

Hardware:

Bed Size:235 * 268 ** 2 mm
Print Size:220 * 220 mm
Compatible with Creality ender3 serials.
Material: PCB FR4
Power input:24V
Power connector:XT60
Signal connector:I2C

Software:

Communication protocol: Gcode,Sending heating Gcode M140 or M190,and then with G1 or G0 sending X and Y positon for example: M190 S60 G1 X100 Y10 it will heating the second Zone where the position (100,10) is.

Main board request:

Any board which has 2 free GPIO and run Marlin firmware. configure the 2 GPIO as software I2C port to communicate with Panda BED with Gcode.

Marlin firmware:

The code for marlin firmware have been tested with boards which MCU are ESP32 and STM32, We will pull up to Marlin team later.

now the working firmware is here:https://github.com/markniu/PandaZHU

Github: https://github.com/markniu/PandaSegmentHeatBed