The 'Pi Wire Scorpion' kit is designed to provide a practical enclosure for our 'Nwazet Key Lime Pi' breakout board. Use it as you build your project or as part of a final installation: it will do a great job at securing wires in place thanks to nine built-in zip-tie cutouts. The 'Pi Wire Scorpion' kit accommodates all the features of the 'Nwazet Key Lime Pi', works well with right-angle and straight pin headers and includes all the essential cables and connectors needed to complete your project quickly and neatly.

Bill of Materials

• 2x 'Pi Wire Scorpion' plates (Fluorescent green)
• 1x Raspberry Pi GPIO cable
• 1x JST-PH power cable
• 1x JST-PH power connector
• 40x M/F jumper wires
• 8x 4" x 0.10" zip ties
• 4x rubber feet
• 3x short black screws (bottom plate)
• 3x long black screws (top plate)
• 3x hex F/F standoffs (Key Lime Pi breakout support, bottom plate)
• 3x round spacers (top plate support)

Board dimensions

• Width: 6cm (2.36")
• Length: 8.8cm (3.46")

Mouting holes

The following distances are expressed from center to center of the mounting holes:

• Width: 4.75cm (1.87")
• Length: 7.50cm (2.95")

Assembly time

• ~5 minutes