This beautiful black matte laser-cut case is specifically designed to house a Raspberry Pi (Rev. 1 or 2) with an optional 'Nwazet Pi Power Supply'. It also accommodates our right-angle stereo cable as well as the 'Nwazet Pi IR Receiver'. The vents ensure that the electronics within the case will have sufficient air flow to stay cool. The case ships with the fasteners required to secure the Raspberry Pi and the optional power supply, a clear light pipe and rubber feet. Assembly time is about 15 minutes. The back of the case has four standard VESA 75 screw holes that make it possible to mount your device on the back of a monitor. Last but not least, it has been scientifically proven to pass the 'Living Room Aesthetics Test' 99.99% of the time (a.k.a 'The Spouse Test') ;-)

Specifications

• Black matte acrylic
• Stereo cable routed to the back of the case
• Features vents above the power supply and below the Raspberry Pi
• Works with any Raspberry Pi (even your original rev. 1)
• 3mm thick black acrylic case (6 pieces)
• 3mm thick clear acrylic light pipe (1 piece)
• 4 hex nuts
• 16 screws
• 8 hex aluminum standoffs
• 4 corner / edge nylon standoffs
• 4 rubber feet
• VESA 75 mounting holes
• GPIO ribbon cable slot

Assembly Instructions

• Takes 15 minutes to assemble
• A step-by-step assembly guide will be posted shortly on nwazet.com