Introduction

The Pyxis Wavetable LFO is a Eurorack module built around a 32 bit ARM microcontroller, rather than more traditional analogue technology. This means that it is able to offer a far more flexible take on modulation than most current Eurorack LFO modules, rivalling the capabilities of even some modern software virtual instruments.

The heart of the module is a wavetable scanning oscillator; this allows for smooth "crossfade" between a sequence of four waveforms, allowing an unparalleled number of wave shapes; with user definable waveform sequences, with complete control over ordering, phase, and repetition, this is a massively flexible module.

Features

Wavetable scan between sequences of up to four waveforms; define custom wavetables from 9 waveforms, with control over multiplier and phase of each entry in the table.

• Three switchable frequency ranges: 0 to 1 Hz, 0 to 10 Hz, 0 to 100 Hz

• Voltage control over wavescan, frequency, phase

• Attenuverters on all voltage control inputs; Full control over the effect of incoming signals.

• Retrigger and/or clock input; Retrigger the LFO in response to an incoming gate signal to act as an envelope generator. Quantise the LFO output to either an external or internal clock source, for tempo synced modulation effects.

• OLED screen; Provides intuitive visual feedback on the current state of the oscillator.

• High performance ARM microcontroller; Hardware floating point DSP, 22khz sample rate, 12 bit ADC/DAC resolution.

Tech specs

• 14HP wide
• 25mm deep (measured from front of faceplate to top of tallest component).
• Requires 25mA on the -12v rail, 75mA on the +12V rail. No 5V rail used.

For further information, take a look at the manual (linked below), or send us a message on here :-)