What is it?

LilyGo T-Display S3 GPIO module for the Flipper Zero & a commercially 3D printed snow white case.. check out that print quality, bloody beautiful 👌

Some assembly is required, great excuse to bust out your soldering iron.. even if it's just for 30 seconds (it's only through-hole soldering relax).

The case does have screw posts for mounting the t-display (1.20mm diameter).. I don't recommend using them, instead use some double sided tape along each side of the t-display screen. The double sided tape allows removal of the case if needed, if you chose to use the screw posts the case can't easily be removed after being soldered.

The board also has a recessed reinforced module slot, CC1101 & NRF24 modules are supported.

I/O

• Joystick (up, push, down)
• Two auxiliary buttons (momentary)
• Micro-SD adapter
• Expansion module slot

What's included with sale

• GPIO module
• Case & buttons (white)

Installation requirements

• Lilygo T-Display S3 must be purchased separately (order the "Solder version" which translates to "includes header pins") NOTE: OLED version is NOT supported.
• Double sided tape

Instructions

• Attach some double sided tape along the sides of the LilyGo T-Display screen
• Place the buttons into the case
• Mount the LilyGo T-Display S3 into the case
• Align the T-Display S3 with the GPIO board & solder pins

If you follow the instructions in this order, you'll be left with a perfectly aligned board.

Header pin-out

Firmware

I've created a firmware flasher if you're not interested creating/compiling the firmware yourself: dirty_flasher (BETA)

Additional Info

Sale is for a GPIO board & case only, does not include the LilyGo T-Display or any modules featured in the product images, they are there for demonstration purposes only.

The orange buttons featured in the first product image are from the official T-Display case, white buttons are included with sale (sorry, can't source orange buttons ATM).