Excetra 100

Passive infrared motion sensor with STM32 controlled power MOSFET. Say goodbye to the loud click and blinding flash of a regular PIR sensor! It is possible to attach several of these in branches or even to the same LED strip from several places!

Plug and Play, just hookup power and LED wires and you are good to go. Used for direct control of LED strips and powered from the same supply. Additionally it may be used with 230V as a DALI master device.

Uses SELV (Safety Extra-Low Voltage) 12V DC or 230V (may be modified for 120V AC too).

It comes preinstalled with the Time Diagram Function program. It gently lights up an LED strip from 0 to PWR value, keeps the brightness for a set TIME, swiftly jumps to half it's brightness, to alert the user that it is going off, and after about 8 seconds it slowly distinguishes completely. If at any point a new motion is detected, Excetra will shift back to PWR value.

4 trimmers

• PWR - sets the maximum Brightness
• TIME - sets the time for which the LED strip is on full brightness
• LUX - sets the external illumination threshold
• SENSE - sets the sensitivity of the sensor

Inside

STM32G031F8P6 FDS8817NZ - powerful 30V 15A (offered 8A max current is limited by heat dissipation)

Input / Output

Works both on AC and DC! with idle consumption < 0.5W

with 12V / 24V

up to 8A PWM on output has to be powered by SELF

with 230V

DALI output with no galvanic separation

What do you get?

Plug and play PIR motion sensor with pre-installed Time diagram function. It includes a custom made board with an STM32. It also comes with a design case and PIR sensor itself. All that is needed is to hook it up to a power supply and attach an LED strip and you are good to go!