With this set together with the ColorPod you can make a 3D printer that operates like most other powder based 3D printers. It consists of boxes with electronically controlled moving bottoms. During printing the bottom of the feeder box goes up. The bottom in the model box goes down. A thin layer of powder is wiped from one box to the other.

The colorpod itself is not included in this add on set!

This set was designed because we found that using the ColorPod with powder sprinkler is difficult to get to work with fine powder. With this set you can print with layers of 0.1 mm.

The set consists of:

• 500 gr gecko 3d powder
• 1 HP45 cartridge filled with clear fluid
• 2 plexiglass box cutout set
• 1 plexiglass bridge part
• 2 geared stepper motor
• 4 bottom axis support
• 4 box fixing plate
• 10 nylon M3 screws 5mm
• 1 servo modified for continuous rotation
• 1 resistor 100k on connector
• 1 resistor 820E on connector
• 1 dyneema thread 1200 mm
• 1 screw terminal
• 1 geeetech sync cable
• 1 end switch conversion cable
• 1 5V regulator with cable
• 1 rubber band
• 2 ball bearing with outside diameter 16mm
• 1 stainless steel tube 210X20X2 mm
• 1 supply cable male
• 1 supply cable female
• 1 fuse holder with 2A fuse
• 2 M3 threaded rod 80mm
• 1 M4 threaded rod 96mm
• 1 metal spring
• 2 M2 screw 20mm
• 2 M2 screw 12mm
• 4 M2 nut
• 4 M2 washer

operation instructions at using colorpod with dualbox building instructions at building dualbox set up