US Outlet Case Base

This is the case design I use for all of my BrewPi-ESP builds. It incorporates a standard US duplex outlet and IEC-320 C14 power inlet.

NOTE - This specific listing is for a case I already have printed (which is the one pictured in the photos). It is a slightly older design than the one I have in my repo. The key differences include: - A single "hole" in the back for the PCB/RJ-45 jack - Two posts to hold up the PCB rather than 3

Bill of Materials

In order to assemble this case, you will need the following in addition to the fully assembled "main" controller PCB & common components:

• Also needed (not listed) is one of the two screws that typically comes attached to the top/bottom of the US Duplex Outlet
• The rubber feet, while not required, are highly recommended to prevent the screw heads from resting on the ground
• Also optional are 3 Female "Quick Connectors" which can be used to easily connect wires to the IEC-320 C14 power inlet
• For all of these components, please keep in mind that you will be powering devices that can pull several amps of current. Be certain to select the appropriate gauge of wire for your build.

This listing includes the screws/nuts/rubber feet. I also am offering the IEC-320 inlet as an optional add-on.