You can shoot high speed photos such as popping water balloons, lightning strikes, water splashes or coloured water drops. Device has an internal sound sensor and light sensor. Light sensor cable is 30cm long so you can use light sensor in your laser trigger setups.

Device has a 3.5mm opto-isolated camera port, a 3.5mm opto-isolated flash port.

Push button navigates between functions. First mode is Sound Trigger, then lightning trigger, laser trigger, press to shot, bulb mode.

Also you can set a sensitivity level with sensitivity control, and if you want a delay for triggering you can set it via delay control.

Triggering Modes;

Sound Trigger : Set your camera to bulb mode. Plug your camera and flash to relevant ports. Long press to push button to activate sound trigger mode. Your camera goes to bulb mode and device starts to wait for a sound event. When it detects a sound event, fires the flash and ends the bulb mode.

Lightning Trigger : Press 2 times for lightning mode. Led blinks twice. Long press to push button to start lightning mode. When the sensor detects a change in light level fires your camera.

Laser Trigger : Press 3 times for laser mode. Long press to activate. Drop a laser beam to the light sensor. When a water drop hits the beam it fires flash and ends the bulb mode.

Press to Shoot : Press 4 times for Press to Shoot mode. Led blinks 4 times. Long press to activate mode. Each press releases the shutter. If you want a delayed shoot just use delay control for up to 20 sec. delayed shoot.

Bulb Mode : Press 5 times for Bulb Mode. Set your camera to bulb mode. Long press to activate it. Hit the push button start the bulb mode and then hit again to stop.

All functions (except bulb mode and lightning trigger) have delay control. For Sound and Laser modes you can set it up to 300 milliseconds.

You can check the video for detailed instructions.

• You may need shutter release cable which fits for camera's brand / model.
• Device works with standard 9V battery
• Light sensor cable is 30cm long