0x7b

70 orders since Apr 20, 2017

Markham, ON, Canada

Ships from Canada.

View Store

Overall Rating:

Review Breakdown

Average Ratings

Product: (5.00)

Documentation: (4.67)

Shipping: (4.33)

Communication: (4.00)

All Reviews

Ira | April 28, 2021

Highly recommended!

For Prusa Research MK42 heatbed ***clone***

After searching far and wide around the internet for a suitable replacement heatbed for my work's trusty Prusa i3 MK2s printer, I stumbled upon this listing.
This heatbed works incredibly well, is easy to install, and Joe (who created this heatbed clone and runs this Tindie store) is incredibly helpful, generous, and responsive to emails. I would highly recommended picking one of these up if you need it, you won't be disappointed!

Darren | Jan. 25, 2019

Quality Product

For Mk42 Heatbed Clone and Pinda Auto Leveler combo

The pinda probe is far superior to the one that comes with the Original Prusa Mk2s and the board appears to be very well made. I have not installed the board yet but if the quality is as good as the pinda I will be very happy.

Johnny | May 29, 2018

Great pinda replacement

For Auto Bed Leveling Sensor for Prusa Mk2 3D Printer

My only gripe is the cable at the top is fixed with a connector that screws with the original Prusa extruder. Other than that, perfect.

Response from 0x7b | May 30, 2018

The strain relief is a bit rigid to protect the wires, the majority of failures of the průša version of the probe is wire breakage

it doesn’t interfere with the operation of the extruder

Sam | April 23, 2018

great product, quick shipping to Hong Kong

For Auto Bed Leveling Sensor for Prusa Mk2 3D Printer

A well built pinda probe for my Prusa MK2S, shipping was quick, so I did not have a lot of down time!

Response from 0x7b | May 30, 2018

Thank you

Joe | Oct. 25, 2017

Fine heat bed, works like original

For Prusa Research MK42 heatbed ***clone***

I picked this up to have as spare. My original bed failed and I installed this one while waiting on a warranty replacement of the original. It works exactly like the factory bed. No issues heating or zeroing with probe.
You do need to get a PEI sheet to cover the bed - DO NOT GET 1mm thick if you are using on with a PINDA probe - it won't work as it's too thick. Get the 0.25mm thick sheets - available on Amazon.

Daniel | Oct. 17, 2017

Great job

For Prusa Research MK42 heatbed ***clone***

Great price Beautiful deck that works amazing. Fast saft shipping. No issues at all. Would buy again.