Great kit to connect FRSKY D4R-ll RSSI to Minim Micro OSD
For PWM to Analog RSSI Converter
This kit was the solution to connect the RSSI PWM signal from my D4R-ll to the Analog RSSI pad of the Minim Micro OSD in a neat and clean way. In order for this to work you have to first build the kit and heat shrink wrap it to prevent shorts and damage to the hardware, then connect the TX and GND from the telemetry plug on the side of the receiver to the RSSI pad and GND pad of the micro OSD , then you have to run the KV team GUI on the RSSI section, select:
Imput: ACD
PWM: OFF.
or use the joysticks while on the screen( throttle center and full right YAW and full forward pitch and full right roll) if you have a naze32 setup go to the RSSI section page and select the same above settings.