Looking forward to installing came very well packed, and exactly what I needed to get my first printer build off the ground. I ordered with wires and thermostat, and the MDF bed for my Wilson II build. All looks great wires are high grade and soder joints are spot on hopefully will be able to build in next week or two and leave some additional feedback for how it works on a 12v machine

Lance | Dec. 12, 2017

It's good... a couple of things could be better

For Enclosure for Raspberry Pi 3 and LiFePO4wered/Pi3

All in all it is a good product and when the Pi + battery are installed it is a nice package. Here is how it could be improved:

The assembly instructions are very limited. More would be better.

The design fails to accommodate the pins and solder on the bottom of the Pi. Tightening down the screws can bend the Pi board a bit.

I am surprised there is no opening to access the GPIO pins. I know not everyone wants that but modifying the case to permit access
was a bit tricky.

June | May 22, 2017

Base behavior a little weird, mechanical support not great

For Enclosure for Raspberry Pi 3 and LiFePO4wered/Pi3

Without the drivers installed, the base behavior of the addon board is a little weird -- literally no way to turn off the pi without the drivers installed. Additionally, the mechanical support of the addon board is very poor. It feels like the control board might easily break, and there's limited support for the battery enclosure to be anchored to the pi. Overall, though, it gets the job done, given you provide some form of additional mechanical support for the addon around the pi it's attached to (ie: the LiFePO4 Pi case).

June | May 22, 2017

Base behavior a little weird, mechanical support not great

For Enclosure for Raspberry Pi 3 and LiFePO4wered/Pi3

Previous review was for the LiFePO4 board itself, not for this enclosure. The enclosure is actually pretty awesome, though I do wish it was a little more snug around the pi and had adequate protection for the back end of the battery enclosure, but overall, quite good.

Bernard | Nov. 10, 2016

summary

For Acrylic enclosure for Arduino Uno and 16x2 LCD

If you use an Adafruit LCD shield, it doesn't fit. It looks like it should. But it doesn't. An end piece interferes with the length of the lcd.

Response from Marty Rice | Nov. 10, 2016

Hi Bernard, is this the LCD you are referring to?

https://www.adafruit.com/products/772?gclid=CjwKEAiA0pDBBRCFtoPyguTh8AUSJADNWeuxVzfNBDWednzszL1dvgvuw9PuHe6k0zQie5ObsfZgkhoCDhLw_wcB

I'd like to know more so that I can update the design to work with either shield.

Tindie

Marty Rice

Overall Rating:

Review Breakdown

Average Ratings

All Reviews

Looks Fantastic

It's good... a couple of things could be better

Base behavior a little weird, mechanical support not great

Base behavior a little weird, mechanical support not great

summary

Response from Marty Rice | Nov. 10, 2016