we can not figure out analog mode from the instructions
For AC 60Hz/50Hz Dimmer/SSR Controller Board
If anyone has gotten this unit to work in analog voltage control mode can you please tell us exactly which pins on the 6 pin header to connect.
we have the AC input and AC Load and the 5 volt control signal landed fine... but it is completely unclear how to set up the 6 pin header from the instructions. EXACTLY which pins are tied together. WE ARE NOT USING THE PWM mode
Response from RF Simplicity | Sept. 22, 2016
For everyone's convenience, I have uploaded two more photos to the product page to show exactly which pins need to be connected for both Analog and for PWM operation of the board. I hope this helps! Cheers!
